Insight · Heavy haulage · Updated November 2026
A lowbed trailer in Vietnam is the answer when your cargo is too tall for a flat rack on a container chassis or too heavy for a normal semi-trailer. The questions that decide your date are simple: which lowbed, how many axles, and does the loaded truck pass 2.5 m wide, 4.2 m high or 48 t gross.
Written by our heavy-haul desk in Ho Chi Minh City, which runs our own lowbeds every week. · Jump to the specs table

A lowbed (lowboy in the US) is a semi-trailer with a raised gooseneck at the front and a dropped deck behind it. The deck sits much closer to the road than a container chassis. That lower deck is the whole point: it buys you cargo height under the 4.2 m road limit.
In Vietnam you need a lowbed trailer in three common cases. Each one comes from a limit the agent can check from the packing list before booking.
A lowbed also carries containers when the box plus cargo is too high for a normal chassis. The photo below is one of our lowbeds with a 40′ open top at a terminal gate.

These lowbed trailer Vietnam figures are our own trailers, from our fleet register, not catalog figures. When the lowbed is ours, the date in our quote is a date we control.
| Equipment | Deck and gooseneck | Payload | Typical cargo |
|---|---|---|---|
| 6-axle lowbed (own, 1 unit) | Deck 14.5 m long, 3.2 m wide · gooseneck about 4 m | Up to 62 t | Long machinery, tanks, pressure vessels, several long breakbulk pieces on one deck |
| 4-axle lowbed (own, 2 units) | Deck about 12 m long · gooseneck about 4 m long, 1.6 m high | Up to 44 t each | Drums, tanks, excavators, rollers, cable reels, over-height open tops |
| Prime movers (own) | Heavy-duty tractor units matched to each trailer | Per trailer and permit | Port to site in the south, long-haul to central Vietnam |
| Modular trailers / SPMT (partners) | Hydraulic axle lines, configured per load | Per configuration | Transformers and single pieces beyond our lowbed range |
| Mobile cranes (partners) | 25–500 t | n/a | Loading and unloading where there is no port crane |
Payload is the trailer’s rated figure on its inspection certificate. It is a hard ceiling: an overweight permit lets the vehicle use the road above the general limits, it never lifts the trailer’s own rating.
We tell you in the quote which equipment is ours and which comes from partners. For moves that need modular trailers, see our power transformer transport page.

The lowest-cost truck that passes the limits is the right one. A lowbed trailer Vietnam trip costs more per trip than a container chassis, so we only put cargo on a lowbed when the flat rack option fails on height, weight or length.
| Your cargo | Usual equipment | Why |
|---|---|---|
| On a flat rack, under about 2.4 m tall, within FR payload | Container chassis | Lowest cost; width over 2.5 m still needs a permit |
| On a flat rack or open top, too tall for a chassis | Lowbed with the container on the deck | The lower deck brings the top point back under 4.2 m |
| Loose piece up to about 44 t | 4-axle lowbed | Low deck, our own trailer, short lead time |
| Loose piece up to about 62 t, or long pieces up to 14.5 m deck | 6-axle lowbed | Longer, wider deck; more axles to spread the load |
| Heavier single pieces, power transformers | Hydraulic modular trailer or SPMT (partner) | Axle lines added until each axle is within the bridge limits |
If you are still deciding how the cargo leaves the origin port, read our flat rack container dimensions guide first. The choice of box at origin decides the truck at destination.
Send L×W×H, weight and the pick-up and site. We tell you the truck, the permit class and the lead time within 2 working hours.
The road limits apply to the loaded vehicle, not to the cargo alone. They are set by Circular 12/2025/TT-BXD of the Ministry of Construction, amended by Circular 19/2026/TT-BXD from 1 July 2026 (Ministry of Construction notice).
| Limit | Threshold (vehicle + cargo) | What it means for a lowbed |
|---|---|---|
| Width | Over 2.5 m | Oversize permit; most heavy lowbed loads pass this |
| Height from road to top point | Over 4.2 m (4.35 m for container vehicles) | Oversize permit, plus a check of wires, signs and bridges on the route |
| Length | Over 20 m | Oversize permit; long pieces with rear overhang reach this fast |
| Gross weight | Over 48 t | Overweight permit, often a route survey and bridge check |
Axle loads count too. A single axle is limited to 10 t, a tandem group to 11–18 t and a tri-axle group to 21–24 t depending on axle spacing. A heavy piece placed badly on the deck can break an axle limit even when the gross weight is legal.
Simple arithmetic for agents: tractor plus a 6-axle lowbed plus a 40 t piece is well over 48 t gross. Any loaded 6-axle lowbed near its rating will run on an overweight permit. Plan the lead time of every heavy lowbed trailer Vietnam move around it. The full permit process, documents and validity are on our oversize permit Vietnam page.
Take 4.2 m and subtract the deck height. On our lowbeds the deck is roughly 1 m above the road, so cargo up to about 3.2 m tall usually keeps the loaded truck under 4.2 m without a height permit. We confirm the exact figure per unit, measured after loading, because tires, dunnage and cribbing all add centimeters.
Over that, a lowbed trailer Vietnam move is still possible. It needs an oversize permit, a route survey of wires and overpasses, and sometimes a night move with police coordination. The tallest loads we move in the south are drums and tanks of about 3.8–4 m diameter, which are far over the height and width limits.

For a tank like this, size decides the job before weight does. At about 4 m wide and well over 4.2 m loaded, the move needed its own permit, a route check and, under our rules, a lead and a rear escort car.
Weight picks the number of axles. Size picks the permit and the route.
A lowbed trailer Vietnam move goes wrong at loading more often than on the road. These are the rules our crew works to before the truck leaves the gate.
Two recent lowbed trailer Vietnam jobs on our own trailers. Customer names are left out; routes, sizes and dates are real.

The tank is the one pictured in the height section above. For more moves, including cable reels to Khanh Hoa and pressure vessels to the Cambodian border, see our heavy haulage Vietnam page.
We do not publish a flat lowbed tariff, and you should be careful with anyone who does. Two pieces of the same weight can need different trailers, permits and escorts. We price each lowbed trailer Vietnam move from the dimensions, and the quote shows every line.
| Cost driver | How it changes the rate |
|---|---|
| Trailer class | 4-axle lowbed costs less per trip than the 6-axle; modular trailers are priced per axle line and day |
| Distance and road | Kilometers, toll roads, and whether the permit forces a longer route around weak bridges |
| Permit class | No permit, a simple oversize permit, or an overweight permit with survey and bridge check |
| Escort and police | Escort cars for very wide loads; police coordination for night moves and difficult sections |
| Time windows | City truck curfews and night-only moves add crew hours |
| Lifting | Port crane, mobile crane at the site, or both; crane size follows weight and reach |
| Waiting time | Truck days waiting for cargo, customs or site access are charged per day |
For a baseline, our public trucking table for standard 20′ and 40′ boxes from Hai Phong port starts at VND 2,100,000 per trip inside Hai Phong and reaches VND 12,700,000 to Nghe An (rates as of 11 October 2026, excluding VAT and lift-on/off). A lowbed trip on the same distance costs more. See the Haiphong port page for the zone table.
What you get from us is a net rate for network members, valid for a stated period, with the permit, escort and crane lines split out. If the measured cargo differs from the drawing, we tell you before the truck moves, not after delivery.
In the south we load lowbeds at Cat Lai, Cai Mep–Thi Vai and Ben Nghe ports, and at factories and fabricators across Dong Nai, Binh Duong and Ba Ria–Vung Tau. Many heavy pieces never see a port: they leave a local fabricator at night and reach the plant before the morning truck curfew ends.
Port-specific notes for flat racks and breakbulk are on our Cat Lai port guide and the breakbulk and heavy lift page.

Add a drawing and the center of gravity if you have them. We reply with the trailer, the permit class, escort needs and an honest lead time.
Our own lowbed fleet, route surveys and escort from port to site.
Heavy haulage →Send the dimensions, weight and route. We reply with the trailer, permit class and net rate within 2 working hours. We never contact your customer.
Tony Tuan, CEO: WhatsApp +84 909 411 668 · ceo@projectshipping.vn
Nura Tu, Overseas Department: WhatsApp +84 906 770 650 · overseas@projectshipping.vn
Network partners: agent page · Calling from Vietnam: 0909 411 668
Last updated: November 2026 · By Tony Tuan, CEO, Project Shipping




© 2017 – 2026 Project Shipping. Design by Thiết kế Web DC